Senders
Fifth Wheel Sender
B92100.
This sender bears against a wheel so that it turns as the striper
moves. The wheel can be a truck tire, a dolly tire, or an idler wheel
that rides on a vehicle tire. Maximum speed is 30MPH or 48 km/hr.
This part has been replaced by B92110B with a
zero speed sender. Individual parts of the old and new sender are not
interchangeable. New photo is coming.
Mechanical Transmission
Sender A92250.
This sender installs on the speedometer hub on the transmission. It provides a
pass-through drive for the instrument panel speedometer cable. Thread is SAE
standard 7/8-18 on both ends. Drive tangs can be Square at 0.105, 0.150 or 0.195
inches, or a round with flag with a diameter of 0.153, 0.190, or 0.204 inches.
Also available with metric threads and tangs for imported transmissions.
NEW!
Drive Shaft
Sender A94418. This is a
custom made sender that mounts on the vehicle drive shaft. It is supplied
with a separate Hall-effect sensor that must be mounted adjacent to the magnet
ring. When ordering this sender, allow several weeks for the custom machine
work. Maximum speed is 3000 RPM. As
this is a custom part, it is not returnable for credit.
Electronic Sender
Adapter, Model SA1. This adapter
allows the speedometer signal generated by some transmissions to be used to
operate MSDI products. Note that not all integral transmission senders generate enough pulses
per foot to operate a skipline control. Most can operate a speedometer, however.
